2.1 Scanner Unit
1. Open the scanner unit cover.
2. Disconnect plugs P611, P801 and P821.
3. Unfasten the transceiver module (two bolts). Remove the transceiver module.
WIRING
CAUTION
The magnetron in the transceiver module will de-
magnetize if it contacts ferrous material. When
dismounting the transceiver module, lay it on its
side or on top of non-ferrous material as shown
below.
J611
J801
J821
Figure 2-1 Scanner unit, front view
Transceiver module
(magnetron inside)
Non-ferrous
block
Height more
than 5 cm
2-1
Fixing
bolts