Fastening The Scanner Unit To The Mounting Platform - Furuno FR-2115/2125 Installation Manual

Antenna radiator
Guide pin
(XN20AF,
Figure 1-3 Fastening the radiator to the radiator bracket

Fastening the scanner unit to the mounting platform

The scanner unit may be assembled before hoisting it to the mounting platform.
However, do not lift the scanner unit by the radiator. Always hold the unit by its
housing. When using a crane or hoist, lift the unit by the hoist rings which should
be fastened to the bolt fixing covers of the scanner housing.
DO NOT lift the antenna unit by the radiator; lift it by the
hoist rings. (Be sure to remove rings after hoisting the
antenna unit.)
Hoist
ring
1. Construct a suitable mounting platform referring to the outline drawing at the
back of the manual.
2. Drill four mounting holes of 15 mm diameter and one cable entry hole of about
50 mm diameter in the mounting platform.
3. Lay the rubber mat (supplied) on the mounting platform.
XN24AF
only)
CAUTION CAUTION
130cm
1-3
Waveguide
Radiator bracket
Hex bolt (M8X40), 8 pcs.
(XN20AF, XN24AF only)
Hex bolt (M8X35), 8 pcs.
Flat washer
Spring washer
(XN12AF only)
O-ring
NO!