Furuno FR-2115/2125 Installation Manual page 41

4) Connect the GYRO CONVERTER Board to the INT Board (cables supplied
with GC-8) as shown below.
5) Confirm gyrocompass specifications and set up the DIP switches and jumper
wires on the GYRO CONVERTER Board according to gyrocompass connected:
• Setting jumper
specifications: page 4-3
• Setting jumper
model of gyrocompass: page 4-5
• Location of jumper wires and DIP switches: page 4-6
6) Solder the gyrocompass cable to the VH connector assemblies (supplied).
7) Attach instruction label (supplied) to the shield cover for the INT and GYRO
CONVERTER boards.
8) Close the display unit.
9) Turn the power off and on to reset the CPU.
J446
J465
INT BOARD
03P9252
GYRO CONVERTER
BOARD 64P1106
Figure 4-2 Display unit, inside view
wires and
wires and
4-2
J5
To gyro
J4
J7
J1
Fix cable to chassis
with cable tie.
DIP switches
DIP switches
by gyrocompass
by make and