Installation; Equipment List; How To Install The Display Unit - Furuno 1815 Operator's Manual

1.

INSTALLATION

1.1

Equipment List

Name
Display Unit
Antenna Unit
Mounting Base
Installation Materials
Radome Mounting Bracket
External Buzzer
NMEA Data Converter
Junction Box
Cable Assy.
Flush Mount Kit
1.2

How to Install the Display Unit

Do not use paint, anti-corrosion products, contact spray or
other items containing organic solvents on the equipment.
Organic solvents can harm paint and plastic, particularly the con-
nectors.
The display unit can be installed on a desktop or flush mounted in a console. Do not
install the unit on the overhead or a bulkhead. Select a suitable location for the unit
considering the following points:
• Select a location where the controls can be easily operated.
• Locate the unit away from the direct wind from air conditioners.
• The temperature range in the mounting location should be -15°C(5°F to 55°C(131°F).
• Locate the unit away from devices that emit active gas.
• The mounting location must be well ventilated.
• Select a location where vibration and shock are minimal.
• A magnetic compass will be affected if the display unit is placed too close to the com-
pass. Observe the compass safe distances in the safety instructions to prevent inter-
ference to the compass.
• Locate the unit away from direct sunlight to prevent heat build up inside the cabinet
and condensation in the display.
• Keep the unit away from water and water splash. (The unit complies with waterproofing
specification IP5.)
Desktop mount
Fasten the unit to the mounting location as shown below. For mounting dimensions,
see the outline drawing at the back of this manual.
Type
RDP-157
RTR-120
RTR-120
CP03-37600 000-033-122
CP03-37610 000-033-123
CP03-37620 000-033-124
OP03-209 001-078-350
OP03-21 000-030-097
IF-NMEA2K2 000-020-510
FI-5002 000-010-765
FRU-CF-FF-30M 001-464-290
OP03-242 0001-464-280
CAUTION
Code No. Qty
— 1
— 1
— 1
Select
one
1
1
1
1
1
1
Remarks
Option
Option
Option
1-1