Using The Monitor; Installing / Changing The Batteries; Installing The Cuff Holder - A&D UA-782 Instruction Manual

Installing / Changing The Batteries

1. Remove the battery cover.
2. Remove the used batteries and insert new batteries
into the battery compartment as shown, taking care
that the polarities (+) and (-) are correct.
3. Replace the battery cover.
Use only R6P, LR6 or AA batteries.
CAUTION
Insert the batteries as shown in the battery
compartment. If not, the device will not work.
When (LOW BATTERY mark) blinks on the display, replace all batteries
with new ones. Do not mix old and new batteries. It may shorten the battery
life, or cause the device to malfunction.
(LOW BATTERY mark) does not appear when the batteries are drained.
Battery life varies with the ambient temperature and may be shorter at low
temperatures.
Use the specified batteries only. The batteries provided with the device are
for testing monitor performance and may have a limited life.
Remove the batteries if the device is not to be used for a long time.
The batteries may leak and cause a malfunction.
The stored data are cleared when the batteries are removed.
When the AC adapter is used for measurement, memories are cleared
after pulling out the AC adapter.

Installing The Cuff Holder

This monitor comes equipped with a removable cuff holder for your convenience.
When not in use, simply slip your cuff into the holder for storage.
To install the cuff holder:
1. Align the cuff holder with the rear of the blood
pressure monitor.
2. Slide the cuff holder into the rear of the blood
pressure monitor until it snaps securely into place.
To remove the cuff holder:
1. Push the tab on the cuff holder away from the
blood pressure monitor.
2. Slide the cuff holder away from the blood
pressure monitor as shown.

Using the Monitor

6