Removable Media Devices - NEC LE2200 User Manual

Removable Media Devices

Bay A
IDE CD-ROM (master device) (always installed)
Bay B
IDE Tape (slave device)
1st SCSI Tape (SCSI address 2) Device must have the internal
SCSI terminators installed.
Bay C
2nd SCSI Tape (SCSI address 5) Device must have the internal
SCSI terminators removed.
Bay D
1.44M floppy (always installed)
Removable media devices can be installed in peripheral
bays A, B, and C. An IDE CD-ROM drive is always
mounted in bay A. A 3.5-inch diskette drive is always
mounted in bay D. Other IDE or SCSI optional devices
should be installed in the first available bay from the
top (bay A). The following table illustrates the
recommended removable media configuration.
BAY A
BAY B
BAY C
BAY D
or
Notice: When using SCSI optional devices, the system
board internal SCSI termination resistors (see Figure 4-
7) must be removed and the SCSI termination resistors
must be installed in the last SCSI drive of the daisy
chain cabling. All other SCSI devices must have their
terminators removed.
Notice: When using an IDE optional device, the device
jumper must be set as the slave device.
Upgrades and Options
4-29