NEC LE2200 User Manual page 107

5-9
Monitoring POST while it is running
Each time you turn on the system, the power-on self-
test (POST) runs automatically and checks the system
board, CPU, memory, keyboard, and most installed
peripheral devices.
During the memory test, POST displays the amount of
memory that it is able to access and test. Depending on
the amount of memory, it may take several minutes to
complete the memory test.
Press F2 key if you want to run SETUP
If you do not press <F2>, the above message remains for
a few seconds, the system beeps once, and the boot
process continues.
If POST finds an error, it displays an error message
and, in case there is a problem with the display, puts
out a series of long and short beeps. Write down any
beep code emitted. This information is useful to your
service representative.
One short beep means the system passed POST. Refer to
the BIOS User's Information section in this chapter for
a list of items to check for each error code and for an
explanation of the error beep codes.
Table 5-1 lists keys active during POST and provides a
description of errors that may occur.
The BIOS indicates errors by writing an error code to
the PS/2-standard logging area in the Extended BIOS
Data Area, and by displaying a message on the screen,
which is sometimes preceded by the POST Error Code.
The error code will also be logged to the Event Logging
area.
Report any error code to your service representative.
Problem Solving