NEC LE2200 User Manual page 84

4-24
Upgrades and Options
7. Slide the drive bay towards the top of the chassis
until the tabs on the bay are free from the chassis.
Remove the drive bay from the chassis and place it
on an antistatic surface.
8. Install the hard disk drive component side down.
Slide the drive into the bay until the screw holes line
up. It may be necessary to temporarily loosen the
mounting screws on the already installed drives to
position the new drive. Secure the drive to the bay
with the four supplied screws.
9. Replace the 3.5-inch drive bay. Insert the tabs into
their slots on the chassis. Slide the drive bay towards
the bottom of the chassis until the tabs hit their
stops.
10. Connect the signal and power cables to the drives as
shown in Figure 4-11.
Note: All device power cables are labeled and must
be installed in specific locations as shown in Figure
4-11. Also, the hard drive cabling configuration may
be different in your system if your system includes
the DAC960PDU Disk Controller Board. However,
cable connections to the hard disk drives are the
same.
11. Swing the drive bay into the chassis and replace the
3 screws on the drive bay.
Figure 4-11. Cabling Hard Disk Drives
DRIVE POWER
LOCATION CONNECTOR
1 PS12
2 PS4
3 PS5
4 PS13