Raid Configuration - NEC LE2200 User Manual

A-5

RAID Configuration

One of the options available for your system is the
single channel DAC960 Redundant Array of Inexpensive
Devices (RAID) Controller board, which gives your
system the added security of fault tolerance. If you
order a system with the RAID controller, the system is
pre-cabled at the factory (see Figure A-3).
If you are adding the DAC960 controller to an existing
system, you must install, cable, and configure the
controller. Refer to The Installing an Option Board
section in the Upgrades and Options chapter to install
the controller. Once you have installed the controller,
remove the wide SCSI interface cable (Figure A-1, J)
from the mother board and plug it into the channel 0
connector on the RAID controller. In addition, connect
the activity cable (Figure A-3, X) from the RAID
controller to J42 on the system board.
System Cabling