Installing An Internal Scsi Hard Disk Drive - NEC LE2200 User Manual

Installing an Internal SCSI Hard Disk Drive

1. Power off the system and remove the side panel as
described earlier in this chapter.
Notice: Observe static precautions. Use an antistatic
wrist strap.
2. Remove the 3.5-inch hard disk drive from its
protective wrapper. Record the drive model and
serial number in the equipment log.
3. Set any drive jumpers or switches as described in the
installation procedures that came with the device.
Notice: If a drive bezel is installed, it must be removed
because it blocks the air flow around the drive.
Notice: The "Terminator Enable" jumper must be
installed in the last hard disk drive of the daisy chain
cabling (top drive bay 1, SCSI ID = 0). The SCSI
terminators must be removed from all other drives.
4. Remove the screw holding the 3.5-inch drive bay to
the chassis (Figure 4 -10).
5. Disconnect the power and signal cables from the
installed drives.
6. Swing the drive bay out of the chassis.
Figure 4-10. Removing the 3.5-inch Drive Bay
Internal
Bay
Remove Drive
Bay Screw
Upgrades and Options
4-23