Exiting Scsiselect; Configuring The Optional Raid Controller - NEC LE2200 User Manual

3-22
OPTION
Extended BIOS Translation for DOS Drives >1
GByte
Host Adapter BIOS (Configuration Utility
Reserves BIOS Space)
Support Removable Disks
Under BIOS as Fixed Disks
Display <Ctrl-A> Messages During BIOS
Initialization
BIOS Support for Bootable CD-ROM
BIOS Support for Int13 Extensions
1
No effect if BIOS is disabled.
2
Do not remove media from a removable media drive if it is under BIOS control.
3
Set to Disable if NetWare 3.12 or 4.11 Network Operating System is installed.
Exit ing SCSISelect

Configuring the Optional RAID Controller

Configuring Your System
Table 3-7. SCSISelect Setup Configurations (Continued)
RECOMMENDED SETTING
Enabled
Enabled
Boot Only
1, 2
Enabled
Disabled
Enabled
To exit SCSISelect, press ESC until a message prompts
you to exit (if you changed any settings, you are
prompted to save the changes before you exit).
One of the options available for your system is the
single channel DAC960 Redundant Array of Inexpensive
Devices (RAID) Controller board, which gives your
system the added security of fault tolerance.
If you order a system with the RAID controller, the
system is pre-configured at the factory. Use Table 3-8 to
determine how the RAID controller was configured at
the factory. If you want to change the RAID level or add
additional hard disks to the array, you must use the
DACCF utility.
If you are adding the RAID controller to an existing
system, the DACCF utility allows you to configure your
disk array before installing your network operating
system.
OR DISPLAY ONLY
1
1
1
1
1
YOUR
CONFIGURATION