Furuno GD-1700 Operator's Manual page 67

7. Press the SAVE soft key.
8. Press the [MENU] key to close the menu.
Editing a waypoint from the plotter display
You may edit waypoints from the plotter display as follows:
1. Press the [MENU] key followed by the WAYPOINTS/ROUTES and
WAYPOINTS soft key to open the waypoint menu.
2. Press the WAYPOINT BY CURSOR soft key.
3. Operate the cursor pad to place the cursor on the waypoint which you want
to change. A flashing diamond mark appears on the waypoint when it is
correctly selected.
4. Press the EDIT/MOVE soft key. Three soft keys replace the EDIT/MOVE soft
key:
EDIT WPT: Edit from the waypoint entry window.
MOVE WPT: Move waypoint to new position with the cursor.
ERASE WPT: Erase waypoint. See paragraph 2.8.3.
5. Press appropriate soft key. For "EDIT WPT," the waypoint entry window
appears; edit data as appropriate. For "MOVE WPT," do the following:
a) Operate the cursor pad to place the cursor on the location desired for the
waypoint. A line connects previous position and new position.
b) Push the [ENTER] knob. The waypoint moves to the cursor position and its
position is changed on the waypoint list. If the waypoint is set as
destination or is part of a route, you are asked if you are sure to move the
waypoint. In this case, push the [ENTER] knob to move the waypoint, or
press the [CLEAR] key to cancel.
c) Press the [MENU] key to finish.
(1) Select waypoint to move,
then press EDIT/MOVE
and MOVE WPT soft keys.
(2) Drag cursor to new position,
then push the [ENTER] knob.
34 22. 3456'N 359.9
+
080 22. 3456'E 59.9 nm
16.0nm
FISH
BRIDGE
WP-002
Plotter display
2. PLOTTER OPERATION
NU
M TRIP
99.9 nm
Press to alternately display
range/bearing from own ship
to cursor, range/bearing from
RNG
original waypoint position to
BRG
cursor position.
Below is an example of the
range/bearing from original
waypoint position to cursor
CANCEL
position.
+
2-33