Furuno BACK GP-80 Operator's Manual page 61

2) To quit loading, press the [NU/CU ENT]
key. The cursor shifts to Stop.
3) To start loading, select Start.
4) Press the [NU/CU ENT] key.
Loading waypoint data from
YEOMAN equipment
1) Do steps 1 through 9 in "Loading light-
house data."
2) Press t or s to select WPT.
3) Press to select Command.
4) Press s to select Start. The message shown
in Figure 8-18 appears.
Are you sure to load ?
ENT: Yes MENU:No
Figure 8-18
5) Press the [NU/CU ENT] key. The mes-
sage shown in Figure 8-19 appears.
Now loading
Waypoint data !
MENU:Stop
Figure 8-19
6) Operate the YEOMAN to output data.
When data is loaded, the cursor automati-
cally shifts to "Stop". Waypoints are
loaded into empty areas. When the
waypoint area becomes full, the message
shown in Figure 8-20 appears.
Waypoint area is full !
Can't load any data
Press any key to stop
Figure 8-20
7) When the data is loaded, press [CU/NU
ENT] and [MENU ESC]. The message
shown in Figure 8-21 appears.
The number of valid and invalid
waypoints appears in the message.
Loading completed
Valid waypoint
Invalid waypoint : 0
Press any key
Figure 8-21
8) Press the [MENU ESC] key twice.
Saving data to personal computer
Waypoint and route data can be saved to a
personal computer.
1) Press [MENU ESC] [9] and [5].
2) Press or to select Level.
3) Press t or s to select level; RS232C or
RS422.
4) Press the [NU/CU ENT] key. "Data" ap-
pears in reverse video.
5) Press s to select Com.
6) Press to select Next Page.
7) Press or to select Baud Rate.
8) Press t or s to select baud rate;
4800bps, 9600bps, or 19200bps.
9) Press to select Command (under the
Save Data line). Stop, on the same line as
Command, appears in reverse video.
10) Press s to select Start. The message
shown in Figure 8-22 appears.
Are you sure to save ?
ENT: Yes MENU:No
Figure 8-22
: 0
8-9