Unable To Print Photos; Check That Power Is On; Unable To Start Printing Or Make Settings; Printing Stops Halfway - Epson IP-100 Setup And Direct Printing Manual

Unable to Print Photos

Note:
If you encounrer problems while using the printer with your computer,
see "Problem Solver" in the Online Guide.

Check that power is ON

Check that the power card is plugged into the electrical outlet.

Unable to start printing or make settings

Check that the PC card is properly loaded in the printer's card
slot.
Check that the PC card has data in it.
Check if any error code is displayed.
The error code is displayed when ink runs out, when there is no
paper, or when a paper jam occurs.
See "Error Indicators" on page 6-2.
Check if the error code "E3" is displayed.
Photographs cannot be printed out if the Input switch is set to the
EXT side. Set the Input switch to INT and turn the printer off and
on again.
See "Selecting the Input Switch" on page 2-12.

Printing stops halfway

Check if the PC card was ejected during processing or while the
light was flashing.
Load the PC card into the printer's card slot and print again.
Troubleshooting
6
6-5