Plugging In The Printer; Installing The Ink Cartridges - Epson IP-100 Setup And Direct Printing Manual

Plugging in the Printer

1. Make sure that the printer is turned off. It is off when the P
Power button protrudes slightly from the surface of the control
panel.
2. Check the label on the back of the printer to make sure the
voltage required by the printer matches that of the electrical
outlet you will be plugging it into. Also, make sure that you
have the correct power cable for your power source.
Caution:
c
It is not possible to change the printer's voltage. If the rated
voltage and your outlet voltage do not match, contact your
dealer for assistance. Do not plug in the power cord.
3. If the power cord is not attached to the printer, connect it to
the AC inlet on the back of the printer.
4. Plug the power cord into a properly grounded electrical
outlet.

Installing the Ink Cartridges

Before installing the ink cartridges, note the following.
Warning:
w
The ink cartridges are self-contained units. Under ordinary use,
ink will not leak from a cartridge. If ink does get on your hands,
wash them thoroughly with soap and water. If ink gets into your
eyes, flush them immediately with water.
Setting Up Your Printer
1
1-3