Contents Recirculating; Attach Mounting Plate To Wall; Preparation Of Top - GE JVM1430 Installation Instructions Manual

Installation Instructions
RECIRCULATmNG
(Non-Vented #uctUess}
INSTALLATION OVERVIEW
|
el. Attach Mounting Plate to Wall
C2. Prepare Top Cabinet
C3. Check Microwave Assembly
CA. A(ljust Blower
C5. Mount the Microwave Oven _ ....
/
C6. Install Charcoal Fiher
I-_ ATTACH THE MOUNTING
PLATE TO THE WALL
\
Attach the plate to the wall using toggle bolts. At
least one wood screw must be used to attach the
plate to a wall stud.
[] Remove the toggle wings flom the bolts.
[] Insert the bolts into the mounting plate through
the holes designated to go into dD_vall and
reattach the toggle wings to %" onto each boh.
To use toggle bolts:
Spacing f orToggles
MoreThan Wall
+l_-.-[.--Th ckness
Wings
Mounting
Plate
,,i,
Bolt End
[] Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall to
mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly
centered under the cabinet.
CAUTION: Be careflfl to avoid pinching fingers
between the back of the mounting plate and the wall.
[] Tighten all bolts. Pull the plate away flom the wall
to help tighten the bolts.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
You need to drill holes for the top support screws and
a hole large enough for the power {ord to fit through.
• Read the instructions on the TOP (ABINET
TEMPI ATE.
• Tape it underneath the top cabinet.
• Drill the holes, tollowing the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the (abinet bottom.
19