Mount The Microwave Oven - GE JVM1430 Installation Instructions Manual

Installation Instructions
MOUNT THE MICROWAVE
OVEN
FOR L4SIER INSTAI,IATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use tile nylon
grommet around tile power cord hole to prevent
cutting of tile cord.
NOTE: We recommend using filler blocks if the
cabinet flom hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from over
tightening screws.
NOTE: When mounting
tile
illi(rowave oven,
thread power cord
through hole in bottom of
top cabinet. Keep it tight
y
flu oughout Steps 1-3. Do [] Lift microwave, tilt it
not pinch cord or lift oven tinward, and hook
by pulling cord. _ slots at back bottom
edge onto Ibm lower
tabs of mounting
plate.
_ Rotate flont of oven
up against cabinet
bottoln.
[] Insert a self aligning screw through top center
cabinet hole. Temporarily seolre the oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
CabinetFront
CabinetBottomShelf
FillerBlock
T quivalent
to Depth
of Cabinet
Recess
Self-AligningScrew
[] Insert 2 sell:aligning screws
through outer top cabinet
holes. Turn two flfll turns on
each
screw.
[] Tighten center
screw completely.
[] Tighten tile outer two screws to tile top of the
microwave oven. (While tightening screws, hold
tile microwave oven in place against tile wall and
tile top cabinet.)
1400and 1600Series 1800Series
[] Install grease tihers. See tile Owner's Manual
packed with tile microwave.
18