Outside Top Exhaust; Attach Mounting Plate To Wall; Damper - GE JVM1430 Installation Instructions Manual

Installation Instructions
OUTSIDE TOP EXHAUST
(Vertical Duct)
INSTALLATION OVERVIEW
A 1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Check Damper Operation
A4. Mount Microwave Oven
A5. Adjust Exhaust Adaptor
A6. Connect Duc/work
I-_ ATTACH THE MOUNTING
PLATE TO THE WALL
_=
\
Attach the plate to tile wall using toggle bolts. At least
one wood screw must be used to attach the plate to a
wall stud.
[] Remove tile toggle wings flom the bohs.
[] Insert the bolts into the mounting plate
through tile holes designated to go into (h)_vall
and reattach the toggle wings to ¾" onto each bolt.
To use toggle bolts:
Spacing f orToggles
MoreThan Wall
+l..-.[.--Th ckness
Mounting
Plate
Bolt End
[] Place tile mounting plate against the wall and
insert tile toggle _dngs into the holes in the wall to
I_lount the plate.
NOTE: Befine tightening toggle bohs and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed
flush against the wall and that the plate is properly
centered under the cabinet.
CAUTION: Be careflfl to avoid pinching fingers
between the back of the mounting plate and the wall.
[] Tighten all bolts. Pull the plate away flom the wall
to help tighten the bolts.
12