Switch Management Commands - 3Com 9000 SX User Manual

Switch Management
Commands
Table 4-6 Switch Management Commands
Command
show management
show session
clear session <number>
logout | quit
enable telnet
disable telnet
enable snmp access
disable snmp access
enable snmp trap
disable snmp trap
config snmp add <ipaddress>
config snmp delete [<ipaddress> | all]
config snmp add trapreceiver <ipaddress>
{<comm_string>}
config snmp delete trapreceiver
[<ipaddress> | all]
config snmp community [read | readwrite]
<string>
(continued)
Table 4-6 describes Switch management commands
Switch 9000 Commands
Description
Displays network management configuration and
statics including enable/disable states for Telnet and
SNMP, SNMP community strings, authorized SNMP
station list, SNMP trap receiver list, and logon statistics.
Displays the currently active Telnet and console
sessions communicating with the Switch. Provides the
user name, IP address of the incoming Telnet session,
whether a console session is currently active, and logon
time. Sessions are numbered.
Allows you to terminate a Telnet session from the
Switch.
Allows you to logout of a console or Telnet session. If
used during a Telnet session, also closes the TCP Telnet
session.
Allows you to enable Telnet access to the Switch.
Allows you to disable Telnet access to the Switch.
Allows you to turn on SNMP support for the Switch.
Allows you to disable SNMP on the Switch.
Allows you to turn on SNMP trap support.
Allows you to prevent SNMP traps from being sent
from the Switch.
Allows you to add the IP address of an SNMP
management station to the access list. Up to six address
can be specified.
Allows you to delete the IP address of a specified SNMP
management station or all SNMP management stations.
Allows you to add the IP address of a specified trap
receiver. A maximum of six trap receivers is allowed.
Allows you to delete the IP address of a specified trap
receiver or all authorized trap receivers. If you delete all
trap receiver addresses, any machine can have SNMP
management access to the Switch.
Allows you to configure the SNMP read and write
community strings. The community string can have a
maximum of 32 characters.
4-9