Vlan Commands - 3Com 9000 SX User Manual

4-10 C 4: C
HAPTER OMMANDS
Table 4-6 Switch Management Commands (continued)
Command
config snmp syscontact <string>
config snmp sysname <string>
config snmp syslocation <string>
unconfig management

VLAN Commands

Table 4-7 VLAN Commands
Command
show vlan {<name> | all}
create vlan <name>
delete vlan <name>
config vlan <name> [add | delete]
<portlist> {tagged | untagged}
config vlan <name> tag <vlanid>
config vlan <name> protocol
[<protocol_name> | any]
config vlan <name> ipaddress <ipaddress>
{<mask>}
config dot1q ethertype <ethertype>
unconfig vlan <name> ipaddress
Table 4-7 describes VLAN commands.
Description
Allows you to configure the name of the system
contact. A maximum of 32 characters is allowed
Allows you to configure the name of the Switch. The
sysname appears in the command line interface prompt.
A maximum of 32 characters is allowed. The default
sysname is 3C16990.
Allows you to configure the location of the Switch. A
maximum of 32 characters is allowed.
Restores default values to all SNMP-related entries.
Description
When used with the keyword "all", or with no named
VLANs, displays a summary list of VLAN names with a
portlist and associated status of each. When used with
a named identifier, displays port information including
membership list, IP address, tag information.
Allows you to create a named VLAN.
Allows you to remove a VLAN.
Allows you to add and delete ports. You can specify
tagged and untagged port(s). By default, ports are
untagged.
Allows you to assign a numerical VLANid. The valid
range is from 1 to 4095.
Allows you to configure a protocol based VLAN. If the
keyword "any" is specified, then it becomes the default
VLAN. All packets that cannot be classified into other
protocol-based VLANs are assigned to the default
VLAN of that port.
Allows you to assign an IP address and an optional
mask to the VLAN.
Allows you to configure an IEEE 802.1Q Ethertype. Use
this command if you have another switch that supports
802.1Q, but uses a different Ethertype. The default
value used by the Switch is 8100.
Allows you to remove the IP address associated with a
VLAN.