Winding The Bobbin - Kenmore 385.19106 Owner's Manual

• Winding the bobbin
[lJ Hold the thread with both hands and pass the thread
under the thread guide.
_i_ Thread guide
[2J Guide the thread around the bobbin winding tension
disc. Insert the thread firmly under the bobbin winding
tension disc.
_2_Bobbin winding tension disc
[3J Pass the thread through the hole in the bobbin from the
inside to the outside. Put the bobbin on the bobbin
winder spindle.
_3_Bobbin winder spindle
[4] Push the bobbin winder spindle to the right.
[_1 Hold the free end of the thread in your hand and start
the machine.
Stop the machine when the bobbin has been wound a
few layers, and cut the thread close to the bobbin.
[6J Start the machine again. When the bobbin is fully
wound, it will stop automatically.
Stop the machine and return the bobbin winder spindle
to its original position by moving it to the left, and cut
the thread with a pair of scissors. Remove the bobbin
from the bobbin winder spindle.
NOTE:
The machine will not sew until the spindle has been
returned to the left.
%
%
%
%
20