Removing The Media Card Reader; Replacing The Media Card Reader - Dell Studio XPS 9100 Service Manual

7. Connect the power and data cables to the optical drive.
8. If disconnected, connect the other end of the data cable to the system board connector (see
9. Replace the front bezel (see
10. Replace the computer cover (see
11. Connect your computer and devices to electrical outlets, and turn them on.
12. See the documentation that shipped with the drive for instructions on installing any software required for drive operation.
13. Check the System Setup for drive configuration changes (see
Removing the Media Card Reader
1. Follow the instructions in Before You
2. Remove the computer cover (see
3. Remove the front bezel (see
4. Remove the optical drive (see
5. Remove the screw that secures the Media Card Reader to the chassis.
6. Push and slide the Media Card Reader out through the front of the computer.
7. Disconnect the power and data cables from the back of the Media Card Reader.
1 screw
3 power cable
Replacing the Media Card Reader
1. Follow the instructions in Before You
Replacing the Front Bezel).
Replacing the Computer Cover).
Begin.
Removing the Computer Cover).
Removing the Front Bezel).
Removing the Optical Drive).
2 data cable
4 Media Card Reader
Begin.
System Board
System Setup).
Components).