Dell Studio XPS 9100 Service Manual page 42

WARNING: The computer must be disconnected from the electrical outlet to clear the CMOS setting.
1. Follow the instructions in Before You
2. Remove the computer cover (see
3. Locate the 3-pin CMOS reset jumper (CLR_CMOS) on the system board (see
4. Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and 2.
5. Wait for approximately five seconds to clear the CMOS setting.
6. Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2 and 3.
7. Replace the computer cover (see
8. Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page
Begin.
Removing the Computer Cover).
Removing the Computer Cover).
System Board Components).