Installing A Floppy Drive - Dell Dimension E520 Service Manual

Removing and Installing Parts: Dell Dimension E520 Service Manual
1 drive release latch
7. If you are not replacing the drive, reinstall the drive panel insert (see
8. If you are not replacing the drive, be sure to reflect these changes in system setup. When you restart your computer,
enter system setup (see
value to none.

Installing a Floppy Drive

NOTE: In the event that the replacement or new floppy drive does not have shoulder screws, use the shoulder screws
located within the drive panel insert. Otherwise, reuse the screws attached to the drive that you are replacing.
1. Follow the procedures in
2. Remove the computer cover (see
3. Remove the drive panel (see
4. If this is a new drive installation:
Remove the drive panel insert (see
Remove the four shoulder screws from the insert.
Install two of the shoulder screws on each side of the drive.
file:///T|/htdocs/systems/dimE520/en/SM_EN/parts.htm[10/16/2012 1:05:24 PM]
2 sliding plate
System Setup), then go to the "Drives" section of the BIOS and under Diskette Drive set the
Before You Begin.
Removing the Computer
Removing the Drive Panel).
Removing the Drive-Panel
3 floppy drive
Installing the Drive-Panel
Cover).
Insert).
Insert).