Dell Dimension E520 Service Manual page 60

Removing and Installing Parts: Dell Dimension E520 Service Manual
1 floppy drive
5. Gently slide the drive into place until you feel a click or feel the drive securely installed.
6. Attach the power and data cables to the floppy drive.
7. Connect the other end of the data cable to the connector labeled "FLOPPY" on the system board (see
Components) and route the cable through the clip on the processor shroud.
1 power cable
8. Check all cable connections, and fold cables out of the way to avoid blocking airflow between the fan and cooling vents.
Insert the floppy data cable into the clip on top of the processor shroud.
9. Replace the drive panel (see
10. Replace the computer cover (see
NOTICE:
To connect a network cable, first plug the cable into the network device and then plug it into the computer.
file:///T|/htdocs/systems/dimE520/en/SM_EN/parts.htm[10/16/2012 1:05:24 PM]
2 shoulder screws (4)
2 data cable
Installing the Drive
Replacing the Computer
3 processor shroud clip
Panel).
Cover).
System Board