Installing A Media Card Reader - Dell Dimension E520 Service Manual

Removing and Installing Parts: Dell Dimension E520 Service Manual
1 drive release latch
5. Pull the sliding plate to the right, then slide the drive out the front of the computer.
6. Replace the drive panel insert, as needed (see
7. Replace the drive panel (see
8. Replace the computer cover (see
9. Power up the system and enter system setup (see

Installing a Media Card Reader

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in
the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body
before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface
on the computer chassis.
1. Follow the procedures in
2. Remove the computer cover (see
3. Remove the drive panel (see
4. Remove the drive panel insert (see
panel insert.
5. Remove the Media Card Reader from its packaging.
6. Remove the shoulder screws from the inside of the drive-panel insert and attach the screws to the new Media Card
file:///T|/htdocs/systems/dimE520/en/SM_EN/parts.htm[10/16/2012 1:05:24 PM]
2 sliding plate
Installing the Drive-Panel
Installing the Drive Panel).
Replacing the Computer
Before You Begin.
Removing the Computer
Removing the Drive Panel).
Removing the Drive-Panel
3 Media Card Reader
Insert).
Cover).
). Set the USB for FlexBay value to OFF.
System Setup
Cover).
Insert). Remove the four shoulder screws from the drive