Table of Contents
Advertisement
6
Open the keyboard compartment by following the instructions in
"Replacing the keyboard" on page
Important
You do not need to disconnect the keyboard from the
system board.
7
Gently press outward on the clip at each end of the memory module until
the module tilts upward.
8
Pull the memory module out of the slot.
9
Hold the new or replacement module at a 30-degree angle and press it into
the empty memory slot. This module is keyed so it can only be inserted
in one direction. If the module does not fit, make sure that the notch in
the module lines up with the tab in the memory bay.
Important
Use only memory modules designed for the
Gateway M275.
22.
www.gateway.com
Adding or replacing memory modules
33
Advertisement
Table of Contents
