Setup Summary Using The Xscf Web - Fujitsu SPARC Enterprise M4000 User Manual

20. Configure the Altitude Administration settings.
• Make the Altitude Administration.
Note – Normally, the Altitude Administration is set up by FE. Also, the privilege of
fieldeng is required.
21. Configure the DVD drive/tape drive unit settings.
• Display DVD drive/tape drive unit
information, including connection
information, and configure the devices.
22. Configure the capacity on demand (COD) settings.
• Display and set the COD.
2.1.2

Setup Summary Using the XSCF Web

This section describes the setup summary using the XSCF Web. This procedure
contains examples of the windows that are used. For details on settings, see the
corresponding parts of
Before attempting to establish a connection to the XSCF and log in from the web
browser window of the XSCF Web, perform
Summary by the XSCF Shell" on page
Administration" on page
Section 2.1.1, "Setup Summary by the XSCF Shell" on page
in this section at
In addition, establish one-to-one communication between the PC and the XSCF
during initial setup.
Section 2.2, "Specifying the XSCF Settings" on page
2-54. If you have already performed
Step 9.
showaltitude(8), setaltitude(8)
(See Section 2.2.15, "Altitude
Administration" on page
cfgdevice(8)
(See Section 2.2.16, "DVD Drive/Tape Drive
Unit Administration" on page
showcodlicense(8), addcodlicense(8),
deletecodlicense(8), showcod(8),
setcod(8), showcodusage(8)
(See Section 2.2.17, "COD Administration"
on page 2-131)
Step 1 - Step 8 in
2-2, and enable https in
2-2, start the procedure
Chapter 2
2-127)
2-128)
2-14.
Section 2.1.1, "Setup
Section 2.2.6, "Https
Step 1 to Step 8 in
Setting Up XSCF 2-11