NETGEAR RND4000v2 Software Manual page 25

Change from X-RAID2 to Flex-RAID
You can reconfigure your system from X-RAID2 mode (the factory default mode) to
Flex-RAID mode.

To change from X-RAID2 to Flex-RAID:
1. If any data is stored on your system, back up your data.
For more information, see the
2. Perform a factory reset reboot.
WARNING!
Setting your ReadyNAS system to its factory defaults erases all
data and configuration settings.
The process for performing a factory reset reboot varies by storage system. For more
information about how to perform a factory reset reboot, see the ReadyNAS Duo v2 and
NV+ v2 Hardware Manual.
During the factory reboot process, you have a 10-minute window to choose a RAID
configuration. RAIDar sends a prompt to click the Setup button during this 10-minute time
frame.
3. Launch RAIDar, highlight your storage system, and click the Setup button.
The ReadyNAS Volume Setup screen displays.
ReadyNAS for Home RAIDiator 5.3
Chapter 6, Backup and
Disk Configuration
25
Recovery.