1 M2.5 x 8-mm screws (11)
9. Remove the
Internal Card With Bluetooth® Wireless
10. Turn the computer top-side up and disconnect the touch-pad connector from the system board.
11. Remove the LED board connector.
12. Lift the palm rest and remove it from the computer.
1 touch-pad connector
2 LED board connector
Replacing the Palm Rest
1. Align the palm rest with the bottom plastics and gently snap into place.
2. Reconnect the touch-pad connector to the system board.
3. Reconnect the LED board to the system board.
4. Replace the coin-cell battery.
5. Replace the seven M2.5 x 5-mm screws on the top side of the palm rest.
6. Turn the computer over, and replace the eleven M2.5 x 8-mm screws on the bottom of the computer.
7. Replace the
Internal Card With Bluetooth® Wireless
Technology.
Technology.