Internal Card With Bluetooth® Wireless Technology; Removing The Card; Replacing The Card - Dell Inspiron XPS Gen 2 Service Manual

Back to Contents Page
Internal Card With Bluetooth® Wireless Technology
Dell™ Inspiron™ XPS Service Manual
Removing the Card
Replacing the Card
Removing the Card
CAUTION: Before you begin the following procedure, see the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
NOTE: If you ordered an internal card with Bluetooth wireless technology with your computer, the card is already installed.
1. Follow the instructions in "Before Working Inside Your
2. Remove the M2.5 x 8-mm screw and remove the card cover from the computer.
3. Pull the card out of the compartment so that you can disconnect the card from its cable and remove it from the computer.
1 card connector
2 internal card with Bluetooth wireless technology
3 card door
4 M2.5 x 8-mm screw
Replacing the Card
1. Connect the card to the cable and then carefully insert the card into the compartment.
2. Replace the card cover and the screw.
3. Replace the battery.
Back to Contents Page
Computer."