Display Assembly; Removing The Display Assembly - Dell Inspiron XPS Gen 2 Service Manual

Back to Contents Page
Display
Dell™ Inspiron™ XPS Service Manual
Display Assembly
Display Bezel
Display Panel
Display Latch
Display Assembly

Removing the Display Assembly

CAUTION: Before you begin the following procedure, see the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
1. Follow the instructions in "Before Working Inside Your
2. Turn the computer over and loosen the two captive screws on the Mini PCI card cover.
NOTE: If a Mini PCI card is installed, you will need to remove the antenna cables from the card. If one is not installed, remove the antenna cables from
their secured location.
3. Disconnect the antenna cables from the Mini PCI card.
Computer."