Table of Contents
Advertisement
6. Lift the processor module from the ZIF socket.
Replacing the Processor Module
NOTE:
If a new processor is installed, you will receive a new thermal-cooling assembly, which will include an affixed thermal pad, or you will receive a
new thermal pad along with documentation to illustrate proper installation.
1. Follow the instructions in
Before You
2. Align the pin-1 corner of the processor module with the pin-1 corner of the ZIF socket, then insert the processor module.
NOTE:
The pin-1 corner of the processor module has a triangle that aligns with the triangle on the pin-1 corner of the ZIF socket.
When the processor module is properly seated, all four corners are aligned at the same height. If one or more corners of the module are higher than the
others, the module is not seated properly.
CAUTION:
To avoid damage to the processor module, hold the screwdriver perpendicular to the processor module when turning the cam screw.
3. Tighten the ZIF socket by turning the cam screw clockwise to secure the processor module to the system board.
4. Replace the processor heat sink (see
5. Follow the instructions from
6. Replace the battery (see
Replacing the
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Back to Contents Page
Begin.
Replacing the Processor Heat
step 5
to
step 17
in
Replacing the System
Battery).
Sink).
Board.
Hide quick links:
Advertisement
Table of Contents
