Removing The Processor Module; Replacing The Processor Module - Dell Inspiron 1525 Service Manual

Back to Contents Page
Processor Module
Dell™ Inspiron™ 1525/1526 Service Manual

Removing the Processor Module

CAUTION:
1. Follow the instructions in
2. Remove the processor thermal-cooling assembly (see
NOTICE:
3. To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.
1 ZIF-socket cam screw 2 ZIF socket
NOTICE:
your skin can reduce the heat transfer capability of the thermal pads.
NOTICE:
4. Lift the processor module from the ZIF socket.

Replacing the Processor Module

CAUTION:
NOTICE:
to prevent intermittent contact between the cam screw and processor.
NOTICE:
socket does not require force. A processor module that is not properly seated can result in an intermittent connection or permanent damage to the
microprocessor and ZIF socket.
NOTE: If a new processor is installed, you will receive a new thermal-cooling assembly, which will include an affixed thermal pad, or you will receive a
new thermal pad along with a tech sheet to illustrate proper installation.
1. Align the pin-1 corner of the processor module with the pin-1 corner of the ZIF socket, then insert the processor module.
NOTE:
Great user manuals database on
Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
Before You Begin.
To avoid damage to the processor, hold the screwdriver so that it is perpendicular to the processor when turning the cam screw.
To ensure maximum cooling for the processor, do not touch the heat transfer areas on the processor thermal-cooling assembly. The oils in
When removing the processor module, pull the module straight up. Be careful not to bend the pins on the processor module.
Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
Do not touch the processor die. Press and hold the processor down on the substrate on which the die is mounted while turning the cam screw
Ensure that the cam lock is in the fully open position before seating the processor module. Seating the processor module properly in the ZIF
The pin-1 corner of the processor module has a triangle that aligns with the triangle on the pin-1 corner of the ZIF socket.
UserManuals.info
Removing the Processor Thermal-Cooling Assembly).