1
screws (4)
3
Mini-Card antenna cables
Replacing the Display Assembly
1. Follow the instructions in
Before You
2. Place the display assembly in position and replace the four screws (two on each side) that secure the display assembly to the computer base.
3. Route the display cable into the routing guide and connect the cable to the connector on the system board.
4. Connect the Mini-Card antenna cables to the connectors on the Mini- Card.
5. Turn the computer over and replace the two screws at the bottom of the computer.
6. Replace the palm rest (see
7. Replace the keyboard (see
8. Replace the optical drive (see
9. Replace memory module(s) (see
10. Replace the base cover (see
11. Replace the battery (see
Replacing the
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Display Bezel
Removing the Display Bezel
CAUTION:
The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel.
1. Follow the instructions in
Before You
2
display cable
4
display assembly
Begin.
Replacing the Palm
Rest).
Replacing the
Keyboard).
Replacing the Optical
Drive).
Replacing the Memory
Module(s)).
Replacing the Base
Cover).
Battery).
Begin.