Intel BX80570E8200 - Core 2 Duo 2.66 GHz Processor Design Manual page 14

Term

Sa
TIM
P
MAX
TDP
IHS
LGA775
Socket
ACPI
Bypass
Thermal
Monitor
TCC
DTS
FSC
T
CONTROL
PWM
Health
Monitor
Component
BTX
TMA
14
Sink-to-ambient thermal characterization parameter. A measure of heatsink
thermal performance using total package power. This is defined as: (T
/ Total Package Power.
Note: Heat source must be specified for
Thermal Interface Material: The thermally conductive compound between the
heatsink and the processor case. This material fills the air gaps and voids, and
enhances the transfer of the heat from the processor case to the heatsink.
The maximum power dissipated by a semiconductor component.
Thermal Design Power: a power dissipation target based on worst-case
applications. Thermal solutions should be designed to dissipate the thermal
design power.
Integrated Heat Spreader: a thermally conductive lid integrated into a
processor package to improve heat transfer to a thermal solution through heat
spreading.
The surface mount socket designed to accept the processors in the 775–Land
LGA package.
Advanced Configuration and Power Interface.
Bypass is the area between a passive heatsink and any object that can act to
form a duct. For this example, it can be expressed as a dimension away from
the outside dimension of the fins to the nearest surface.
A feature on the processor that attempts to keep the processor die
temperature within factory specifications.
Thermal Control Circuit: Thermal Monitor uses the TCC to reduce die
temperature by lowering the effective processor frequency when the die
temperature has exceeded its operating limits.
Digital Thermal Sensor: Processor die sensor temperature defined as an offset
from the onset of PROCHOT#.
Fan Speed Control: Thermal solution that includes a variable fan speed which
is driven by a PWM signal and uses the on-die thermal diode as a reference to
change the duty cycle of the PWM signal.
T is the specification limit for use with the on-die thermal diode.
CONTROL
Pulse width modulation is a method of controlling a variable speed fan. The
enabled 4-wire fans use the PWM duty cycle % from the fan speed controller
to modulate the fan speed.
Any standalone or integrated component that is capable of reading the
processor temperature and providing the PWM signal to the 4-pin fan header.
Balanced Technology Extended.
Thermal Module Assembly. The heatsink, fan and duct assembly for the BTX
thermal solution
Description

measurements.
§
Thermal and Mechanical Design Guidelines
Introduction
– T )
S A