Power Save; Power Save Mode; Figure 6.6 Address Translation (Example In Lba Mode) - Fujitsu MHJ2181AT Product Manual

(2) LBA mode
Logical address assignment in the LBA mode starts from physical cylinder 0,
physical head 0, and physical sector 1. If the last sector of a physical track is
used, the track is switched and the next LBA is assigned to the initial sector of the
subsequent physical track.
Figure 6.6 shows an example of 4 heads configuration (assuming there is no track
skew).
230 506

Figure 6.6 Address translation (example in LBA mode)

6.3 Power Save

The host can change the power consumption state of the device by issuing a
power command to the device.

6.3.1 Power save mode

There are four types of power consumption state of the device including active
mode where all circuits are active.
In the power save mode, power supplying to the part of the circuit is turned off.
There are three types of power save modes:
Idle mode
Standby mode
Sleep mode
C141-E088-03EN
231 507 232 508
6
5
5
506
230
6.3 Power Save
505 229 230 506
228 229
504 505
229 505 230 506
1010 458 1011 459
6-9