Fujitsu MHJ2181AT Product Manual page 124

1F7
1F6
1F5
1F4
1F3
1F2
1F1
1F7
1F6
1F5
1F4
1F3
1F2
1F1
(23) IDLE (X'97' or X'E3')
Upon receipt of this command, the device sets the BSY bit of the Status register,
and enters the idle mode. Then, the device clears the BSY bit, and generates an
interrupt. The device generates an interrupt even if the device has not fully entered
the idle mode. If the spindle of the device is already rotating, the spin-up
sequence shall not be implemented.
By using this command, the automatic power-down function is enabled and the
timer immediately starts the countdown. When the timer reaches the specified
value, the device enters standby mode.
Enabling the automatic power-down function means that the device automatically
enters the standby mode after a certain period of time. When the device enters the
idle mode, the timer starts countdown. If any command is not issued while the
timer is counting down, the device automatically enters the standby mode. If any
command is issued while the timer is counting down, the timer is initialized and
the command is executed. The timer restarts countdown after completion of the
command execution.
The period of timer count is set depending on the value of the Sector Count
register as shown below.
C141-E088-03EN
At command issuance (I/O registers setting contents)
(CM) 1 1
H
(DH)
H
(CH) xx
H
(CL) xx
H
(SN) xx
H
(SC) xx
H
(FR) xx
H
At command completion (I/O registers contents to be read)
(ST) Status information
H
(DH)
H
(CH) xx
H
(CL) xx
H
(SN) xx
H
(SC) xx
H
(ER) Error information
H
1 1 1 0
DV xx
DV xx
5.3 Host Commands
0 0
5-51