Alpine PXE-H660 Owner's Manual page 49

...
1---
~ ~INlIlIt_~
r--
'~~'--
' "
oint the remote control at the
remote eye and press "C". Note:
There is an insulator tab under the remote bat-
tery that needs to be removed before use.
Now the car's factory volume control can be
used.
- -
When Position 3 is finished, the
status LED will start flashing once
per second. Move the microphone to
position 4, the middle of the front of
the vehicle. Close all doors and windows again,
and press
"c"
on the remote control. The status
LED shows solid green again
.
r-
-
~,.""_.
, I
- I ..
Press "VOL +" on the remote until
the volume level is set at +35.
Reduce the sub amp (s) levels to l!4 gain (9
o'clock position). Press "Enter" on the PXE-
H660's control panel.
When Position 2 is finished, the
status LED will start flashing once
per second. Move the microphone to
position 3, 30" above the middle rear
seat. Close all doors and windows again, and
press
"c"
on the remote control.The status LED
shows solid green again
l1lil1li
Play track 2 on the PXE-H660's set-up CD.
Press "Enter" on the PXE-H660's control
panel.
Setup process is finished. Press "Enter" on the
PXE-H660's control panel.
When position 1 is finished, the status
LED will start flashing once per sec-
ond. Move the microphone to position
2, at the passengers ear level. Close
all doors and windows again, and press
"c"
on
the remote control. The status LED shows solid
green again
- -
l1li
Turn up the sub gain to the desired level. Press
"Enter" on the PXE-H660's control panel.
Place the microphone in position
1, at the drivers ear level. Close all
doors and windows, and keep the
area around the car quiet. The status
LED should now be blinking once per second.
Press
"c"
on the remote control. The status LED
shows solid green while position 1 is measured.
#/7bILPINE~
PXE-H660 Quick Setup Guide
2009 ©Alpine Electronics of America, Inc. All Rights Reserved.
.$ff/iLPINE.
Mobile Media Solutions