Alpine PXE-H660 Owner's Manual page 17

SETUP PROCEDURE
11. "REM CONTROL PRESS C"
At this point, the PXE-H660 has optimized the input from the factory sound sytem.
Next, the unit will use the included microphone to automatically tune the
aftermarket sound system. Point the remote control at the PXE-H660's external
remote eye. There is an insulator tab under the remote battery that needs to be
removed before use. Press "C" on the remote control to continue.
12. "PUT MIC POS 1 PRESS C "
Prepare to run the calibration test. Position the Mic in location 1 and exit the vehicle.
Close all windows, doors, and the trunk. The car must be a noise free environment.
Outside noises will negatively affect the tuning process and may generate an error
code. Point the remote control at the PXE-H660's external remote eye. Press "C" on
the remote control to continue. The MultEQ LED will be illuminated steady green
while measuring position 1. When the MultEQ LED starts to blink slowly again, Posi-
tion 1 measurement is complete; continue to the next step.
17