Alpine PXE-H660 Owner's Manual page 15

SETUP PROCEDURE
8. "PLAY TRK #2 PRESS ENTER"
Move the track forward to track 2, "AntEq™ Calibration," and play it.
Press "ENTER" to continue.
"ERROR! FULL FREQ MISSING"
If the PXE-H660 displays this error display on the LCD the MultEQ LED will blink
quickly. This error is generated if the PXE-H660 is not receiving the full audible
frequency range from the factory audio system. Troubleshoot the system by making
sure that the correct wires in the vehicle have been used and nothing came disconnect-
ed. Press the "ENTER" button on the remote once the issue has been corrected. The
MultEQ LED blinks slowly again.
9. "2-WAY OFF PRESS ENTER"
The default 'OFF' assumes only a single, fullrange Front Output (Front L2/R2). If the
FRONT Output is configured as a 2-Way system, use the q or p button to change
the value in the HPF field. Refer to page 11 to determine if your system has a 2-Way
output.
Press "ENTER" to continue.
WARNING: Output of the PXE-H660 will not be muted after this point. Turn the fac-
tory radio volume down.
15