SETUP PROCEDURE
17. "SUB AMP UP PRESS ENTER"
This is a reminder to turn the subwoofer amplifier gain back up (from step 10) once all
the measurements have been taken. It is recommended to listen to the system to deter-
mine the proper subwoofer amplifier gain level.
Press "ENTER" to continue.
18. Done
After completing the 4 MIC positions, MultEQ setup will be complete. Unplug and
remove the microphone from the car.
Press "ENTER" to continue.
NOTE:
To repeat setup process follow these steps:
1) Press and hold RESET button for at least 3 seconds but less than 6 seconds.
This resets MultEQ settings (calibration of MultEQ must be redone after reset).
2) Press and hold the RESET button for at least 6 seconds or more.
This resets all settings, restoring the unit to factory default settings (All setup steps need to
be redone after reset).
20