RocketFish RF-TVMP40 Assembly Manual page 7

RF-TVMP40 TV Wall Mount
STEP 3 - Select screws, washers, and spacers
1 Select the screws for your TV. A limited number of TVs come with mounting hardware included. (If there are
screws that came with the TV, they are usually in the holes on the back of the TV.) If you don't know the
correct length and diameter of the mounting screws your TV requires, test various sizes by hand threading
the screws.
Select one of the following types of screws:
M4 × 15 mm screws (M-A)
M4 × 30 mm screws (M-B)
M5 × 15 mm screws (M-C)
M5 × 30 mm screws (M-D)
Select one of the following types of washers:
M4/M5 washers (M-K)
For an irregular or obstructed TV back, use one of the following spacers:
M6/M8 5 mm spacers (M-I)
To avoid potential personal injuries and property damage, make sure that there are adequate
CAUTION:
threads to secure the brackets to your TV. If you encounter resistance, stop immediately and contact
customer service. Use the shortest screw available to accommodate your TV. Using hardware that is too
long may damage your TV. However, using a screw that is too short may cause your TV to fall from the
mount.
Screw is
Screw is
too short
too long
2 Remove the screws.
For 100 x 200 and 200 x 200 mounting configurations, go to "STEP 4: Option 1 - Attaching the monitor plate to
the TV" on page 8.
-OR-
For all other configurations, go to "STEP 4: Option 2 - Attaching the monitor plate with adapters to the TV" on
page 9.
Screw fits
correctly
Need help? Call 800-620-2790
M6 × 15 mm screws (M-E)
M6 × 30 mm screws (M-F)
M8 × 15 mm screws (M-G)
M8 × 30 mm screws (M-H)
M6/M8 washers (M-L)
M6/M8 10 mm spacers (M-J)
7