RocketFish RF-TVMP40 Assembly Manual page 18

STEP 10 - Adjusting the vertical motion
Important! You will need to adjust this product after installation is complete.
Make sure all your equipment is properly installed on the product before adjusting. This product should move
smoothly and easily through the full range of motion and stay where you set it. If movements are too easy or diffcult or
if product does not stay in desired position, follow the adjustment instructions to create smooth and easy movements.
NOTE: Depending on your product and the type of adjustment, it may take many turns to notice a difference.
Any time equipment is added or removed from this product, resulting in a change in the weight of the mounted load,
you should repeat these adjustment steps to ensure safe and optimum operation.
• To increase or decrease the lift tension, use a 1/4" drive socket wrench with the 8 mm socket (P-Q).
Adjusting the factory-set tension
Increase
If TV weight exceeds product's
factory setting, it won't stay up
when raised. To prevent TV from
sagging downward, increase
tension setting.
Decrease
If TV weight is lower than
product's factory setting, it won't
stay down when lowered. To
prevent TV from drifting upward,
decrease tension setting.
18
You'll need
1/4" Drive socket wrench (not
provided) w/8 mm socket P-Q
Need help? Call 800-620-2790
RF-TVMP40 TV Wall Mount