Installer Checklist; Final Instructions; Self-Help Hints - Viking 100 Series Installation Manual

Installer Checklist and Final Instructions
Your installer must have completed and
checked the following:
The dishwasher is square and level.
The dishwasher is fastened securely to the
cabinetry.
The dishwasher door opens and closes
freely. The dishwasher door must close
without hitting any cabinetry or
countertop.
The inlet water supply is turned on and
checked for leaks.
The drain hose has been connected and
checked for leaks. There must be no kinks
or obstructions in the drain hose.
The drain hose must be installed with a
28" (710mm) high drain loop for drain
hook-ups without any air removed.
If the dishwasher drain is hooked up to a
garbage disposal, the drain hopper plug
must be removed.
The spray arms are free and rotate freely.
The rinse cycle has been run.
The water level will be below the filter
screen after the end of the wash program.
It is normal to find some water in the drain
filter area.
Set the water softener to the correct water
hardness for your area. If the dishwasher
drain is connected to a garbage disposal,
make sure that the drain/hopper plug has
been removed.

Final Instructions

• Press the On/Off button to turn the
dishwasher on.
• Power indicator light comes on.
• Use the Program Select button to choose
a washing program.
• Start the program with the
Start/Pause/Cancel button.
• Run the dishwasher through one complete
cycle. When the wash cycle is completed,
use the On/Off button to turn the
dishwasher off.

Self-Help Hints

The screen does not come on:
• Check to make sure the breaker to the
dishwasher is in the on position.
• Check to make sure that the supply cord
is plugged.
No water is coming into the dishwasher:
• Check to make sure the hot water shut-off
is in the ON position.
Water does not drain:
• Make sure drain hose is not kinked or
comes out of air gap next to the sink.
• Remove drain hose from disposal making
sure plug is removed.
28