Performance Checklist; Testing For Leaks; Final Preparation - Viking Professional & Designer 200 series Installation Manual

Installation Procedure (cont'd.)
Air Gap
11A
(Discharge with air gap)
12
Connect water line.
20
11B Air Gap
(Discharge with food waste disposer and air gap)
13
Plug LED light into dishwasher (select
models only) and install kick plate.

Performance Checklist

Testing for Leaks

Unit Reset
• If the unit should need to be reset for any
A qualified installer should carry out the
following checks:
h Remove packaging and parts.
h Turn on the water supply and check for
leaks.
h Turn the power on at breaker/fuse box
and test the dishwasher operation by
running a rinse and hold cycle. (This
should take about 12 minutes.)
h Turn off the electrical power and check
for leaks under the dishwasher.
h Make sure that no kinks have developed
in the drain lines.

Final Preparation

• Some stainless steel parts may have a
plastic protective wrap which must be
peeled off.
21
reason, push and hold the "START" button
for 4 seconds.