Installer Checklist - Viking VDWU524SS Installation Manual

8. INSTALLER CHECKLIST

Your installer must have completed and
checked the following:
• The dishwasher is square and level.
• The dishwasher is fastened securely to
the cabinetry.
• The dishwasher door opens and closes
freely. The dishwasher door must close
without hitting any cabinetry or counter
top.
• The inlet water supply is turned on and
checked for leaks.
• The drain hose has been connected and
checked for leaks. There must be no
kinks or obstructions in the drain hose.
• The drain hose must be installed with a
28" (710mm) high drain loop for drain
hook-ups without any air removed.
• If the dishwasher drain is hooked up to a
garbage disposal, the drain hopper plug
must be removed.
• The spray arms are free and rotate freely.
• The rinse cycle has been run.
• The water level will be below the
filter screen after the end of the wash
program. It is normal to find some water
in the drain filter area.
9. TROUBLESHOOTING:
The screen does not come on:
• Check to make sure the breaker to the
dishwasher is in the on position.
• Check to make sure that the Supply cord
is plugged in.
No Water is coming into the dishwasher:
• Check to make sure the hot water shut-
off is in the ON position.
Water does not drain:
• Make sure drain hose is not kinked or
comes out of air gap next to the sink.
• Remove drain hose from disposal making
sure plug is removed.
Notice :
• If your dishwasher is not operating
properly after following these steps:
Contact your dealer to schedule an
authorized service agent to inspect your
new dishwasher for any function related
failure.
• The manufacturer warranty does not
cover installation, conversion or customer
education service visits.
You will find the model and serial number
information on the label located on the
right-hand side of the inner door of your
dishwasher, as shown above.
Notice :
Please make a copy of your invoice and
keep it with this manual and register your
dishwasher on-line.
22
USA