Final Installation
(cont.)
14
Install kick plate.
16
Performance Checklist
Testing for Leaks
A qualified installer should carry out the following
checks:
Remove packaging and parts.
h
Turn on the water supply and check for leaks.
h
Turn the power on at breaker/fuse box and
h
test the dishwasher operation by running a
rinse and hold cycle. (This should take about
12 minutes.)
Turn off the electrical power and check for
h
leaks under the dishwasher.
Make sure that no kinks have developed in
h
the drain lines.
Final Preparation
• Some stainless steel parts may have a plastic
protective wrap which must be peeled off.
17
Unit Reset
• If the unit should need to be reset for any
reason, push and hold the "START" button for
4 seconds.