Marantz SR7008 Owner's Manual page 232

Contents Connections
Symptom
DTS sound is not output.
Dolby TrueHD, DTS-HD, Dolby Digital
Plus audio is not output.
Dolby PLg mode or DTS NEO:X mode
cannot be selected.
Audyssey MultEQ® XT32, Audyssey
Dynamic EQ®, Audyssey Dynamic
Volume® and Audyssey LFC™ cannot
be selected.
Audyssey DSX® cannot be selected.
"M-DAX" cannot be selected.
No audio is output from PRE OUT or
speakers for ZONE2/ZONE3.
Front panel Display
Playback
• Check that the digital audio output setting on the connected device is set to "DTS".
• Set "Decode Mode" on the menu to "Auto" or "DTS".
• Make HDMI connections.
• Check the digital audio output setting on the connected device. On some devices, "PCM" is
set by default.
• It cannot be selected when "None" is set for "Speaker Config." – "Center" and "Surround".
• These cannot be selected when using the headphones.
• These cannot be selected when you have not performed Audyssey® Setup.
• Switch the sound mode to other than "DIRECT" or "PURE DIRECT".
• These cannot be selected when using the headphones.
• It can be selected when using the front height or front wide speakers.
• It can be selected when using the center speaker.
• Switch the sound mode to DOLBY sound mode or DTS sound mode.
• This cannot be selected when using the headphones.
• Check that an analog signal or PCM signal (Sample Rate=44.1/48 kHz) is input. For playback
of multichannel signals such as Dolby Digital or DTS surround, "M-DAX" cannot be used.
• Switch the sound mode to other than "DIRECT" or "PURE DIRECT".
• In ZONE2/ZONE3, the audio can be played back when signals input from digital connectors
(OPTICAL/COAXIAL) are in 2ch PCM format.
• In ZONE2, the audio can be played back when signals input from the HDMI connector are
in 2ch PCM format. To play back the audio in ZONE2 irrespective of the input signal format,
set the "HDMI Audio" setting in the menu to "PCM". Depending on the played back device,
the audio may not be played back even with this setting. In that case, set the audio format to
"PCM (2ch)" on the played back device.
Rear panel
Settings
Cause/Solution
232
Remote
Tips Appendix
Page
44, 45, 46
Index
–
182
–
193
–
183
120
–
195
193
119
–
165
120
–
204