Bass; Front Speaker - Marantz SR5008 Owner's Manual

Contents

Bass

Set subwoofer and LFE signal range playback.
2 Subwoofer Mode
Select low range signals to be reproduced by subwoofer.
LFE (Default) : The low range signal of the channel set to "Small"
speaker size is added to the LFE signal output from the
subwoofer.
LFE+Main : The low range signal of all channels is added to the LFE
signal output from the subwoofer. This is usually the best
setting for most systems.
%
• "Subwoofer Mode" can be set when "Speaker Config." – "Subwoofer"
(vpage 168) is set to other than "No".
• Play music or a movie source and select the mode offering the strongest
bass.
• If "Front" and "Center" for "Speaker Config." (vpage 168) are set to
"Large", and "Subwoofer Mode" is set to "LFE", no sound may be output
from the subwoofers, depending on the input signal or selected sound mode.
Select "LFE+Main" if you want the bass signals to always be produced from
the subwoofer.
2 LPF for LFE
Set LFE signal playback range. Set this when you want to change the
playback frequency (low pass filter point) of the subwoofer.
80Hz / 90Hz / 100Hz / 110Hz / 120Hz (Default) / 150Hz / 200Hz / 250Hz
Front panel Display
Connections Playback
Rear panel
Settings

Front Speaker

Set the front speakers to use.
%
• This can be set when "Assign Mode" (vpage 167) is set to "Front B".
A (Default) : Front speaker A is used.
B : Front speaker B is used.
A+B : Both front speakers A and B are used.
172
Remote
Tips Appendix
Index